Possible Value; Parser: Textparser - Cisco BTS 10200 Softswitch Manual

Chapter 1 Digit Translations
MGCP_PKG_TYPE
MODE
NUM_OF_TRUNKS
OL-8001-10
Automatic Number Identification/Dialed Number Identification Service Manipulation
Description: Determines the MGCP Package type for the announcement
server.
VARCHAR(16): 1-16 ASCII characters (Default = NA). Permitted values
are:
NA—For SIP and H.323 trunk groups.
ANNC-CABLE-LABS—Announcement signaling type based on the Cable
Labs package.
AUTO—EAOSS signaling. The package is dynamically determined based
on the call type (can be MO, MS, MD). Used when sig-type in CAS Trunk
Group Profile table is EAOSS. For inbound calls, always use the MS
package. (Not supported).
DT—DTMF package.
IT—ISUP trunk package.
LINE—Line package used for Test Line Access.
MD—MF FGD package (Not supported).
MO—MF operator trunks.
MS—MF package.
MT—MF terminating package.
TCL-CISCO (Default)—Announcement signaling type for the Cisco
AS5350/AS5400.
T—Trunk package.
Valid for Command: add, show, change
Default Value: NA
Possible Value: T, IT, DT, MS, MT, MO, TCL_CISCO,
ANNC_CABLE_LABS, NA, LINE
Parser: TextParser.toUpperCase()
Description: Specifies the information returned by the command.
VARCHAR:(8): 1-8 ASCII characters (Default = BRIEF). Permitted values
are:
BRIEF
VERBOSE
Valid for Command: control, show
Mandatory: control
Possible Value: FORCED, GRACEFUL

Parser: TextParser

Description: Not provisionable. EMS provisions this field when trunks are
provisioned for this trunk group.
SMALLINT: 1-9999.
Valid for Command: audit, sync, show

Possible Value: [0_2147483647]

Parser: DecimalParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-85