Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Switch
  5. 6260
  6. Manual

Cisco 6260 Manual

Quad-port flexi atu-c to octal-port dmt atu-c line card conversion procedures
Hide thumbs Also See for 6260:

Advertisement

Quick Links

Download this manual
Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port
DMT ATU-C Line Card Conversion Procedures
This document provides the procedures to convert from quad-port flexi ATU-C line cards (4xflexis) to
octal-port DMT ATU-C line cards (8xDMTs) in the Cisco 6260 system.
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment.
Contents
This document includes the following sections:
•
•
•
•
•
•
•

Conversion Prerequisites

This section provides requirements that are needed to convert your Cisco 6260 system from 4xflexis
to 8xDMTs:
•
Software and Network Management Requirements, page 2
Configuration Requirements, page 2
•
Part and Tool Requirements, page 2
•
Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2001. Cisco Systems, Inc. All rights reserved.
OL-0991-01

Advertisement

loading

Related Manuals for Cisco 6260

Summary of Contents for Cisco 6260

  • Page 1: Table Of Contents

    Obtaining Documentation, page 21 Obtaining Technical Assistance, page 22 • Conversion Prerequisites This section provides requirements that are needed to convert your Cisco 6260 system from 4xflexis to 8xDMTs: • Software and Network Management Requirements, page 2 Configuration Requirements, page 2 •...

  • Page 2: General Safety Precautions And Maintenance Guidelines

    Two Corning Cable Systems (Corning) 120 POTS splitters • The Champ connector pinouts on the back of the Cisco 6260 chassis are mapped for octal-port line cards. If industry-standard unshielded twisted pair (UTP) 50-pin Champ cables are currently used in your configuration, there is no need to change the cables.
  • Page 3 Ennen kuin työskentelet minkään laitteiston parissa, ota selvää sähkökytkentöihin liittyvistä vaaroista ja tavanomaisista onnettomuuksien ehkäisykeinoista. Tässä julkaisussa esiintyvien varoitusten käännökset löydät laitteen mukana olevasta Regulatory Compliance and Safety Information -kirjasesta (määräysten noudattaminen ja tietoa turvallisuudesta). Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 4 Se förklaringar av de varningar som förkommer i denna publikation i dokumentet Regulatory Compliance and Safety Information (Efterrättelse av föreskrifter och säkerhetsinformation), vilket medföljer denna anordning. Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 5 (EMI) that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 6 Do not force the line card into its slot. This action can damage the pins on the backplane if they are • not aligned properly with the line card. Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 7 Follow these guidelines to prevent ESD damage: Always use an ESD ankle or wrist strap and ensure that it makes good skin contact. • Connect the equipment end of the strap to the ESD jack on the front of the Cisco 6260 chassis • card cage.

  • Page 8: Quad-Port Flexi Atu-C To Octal-Port Dmt Atu-C Line Card Conversion Procedures

    Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures The following sections detail the procedures for converting your Cisco 6260 system from 4xflexis to 8xDMTs. Only trained and qualified personnel should be allowed to install, replace, or service Warning this equipment.
  • Page 9 Measure the Rack Space and Prepare the Rack When upgrading your system from 4xflexis to 8xDMTs in a Cisco 6260 with a POTS splitter configuration, you may have to move the hardware components in the rack to accommodate a second POTS splitter as necessary.
  • Page 10 Verify that your Cisco 6260 system is installed from the bottom to the top of the rack so the rack remains stable. If your system is not installed from the bottom to the top of the rack, make the necessary adjustments to the rack.
  • Page 11 Remove the 4xflexis Complete the following steps to remove 4xflexis from the Cisco 6260 chassis: Connect a grounding strap to the ESD grounding jack that is located on the top right of the Cisco 6260 Step 1 card cage.
  • Page 12 Install the 8xDMTs Complete the following steps to install 8xDMTs in the Cisco 6260 chassis: Step 1 Connect a grounding strap to the ESD grounding jack that is located on the top right of the Cisco 6260 card cage. Step 2 Hold the 8xDMT vertically, with the line card faceplate toward you and the connectors facing the chassis slot.
  • Page 13 Verify Correct Fuses Table 4 to calculate the minimum fuse rating that is necessary for each of your Cisco 6260 system components. Verify that your system is using the minimum fuse rating for each component that is wired to the fuse and alarm panel.
  • Page 14 The OUT FAIL LEDs might flash briefly. Verify that the INPUT OK LED lights. Step 2 If the INPUT OK LED does not light or if other issues arise, refer to the Cisco 6260 Hardware Note Installation Guide for troubleshooting procedures.

  • Page 15: Port Mapping Of Subscriber Connectors To Slots And Ports

    In the table, an asterisk (*) indicates a port that is not available on quad-port xTU-C line cards. Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 16 1/8* 18/8* 19/1 19/2 19/3 19/4 2/5* 19/5* 2/6* 19/6* 2/7* 19/7* 2/8* 19/8* 20/1 20/2 20/3 20/4 3/5* 20/5* 3/6* 20/6* 3/7* 20/7* 3/8* 20/8* Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 17 4/8* 21/8* 22/1 22/2 22/3 22/4 5/5* 22/5* 5/6* 22/6* 5/7* 22/7* 5/8* 22/8* 23/1 23/2 23/3 23/4 6/5* 23/5* 6/6* 23/6* 6/7* 23/7* 6/8* 23/8* Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 18 7/8* 24/8* 25/1 25/2 25/3 25/4 8/5* 25/5* 8/6* 25/6* 8/7* 25/7* 8/8* 25/8* 26/1 26/2 26/3 26/4 9/5* 26/5* 9/6* 26/6* 9/7* 26/7* 9/8* 26/8* Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 19 28/4 13/4 28/5* 13/5* 28/6* 13/6* 28/7* 13/7* 28/8* 13/8* 29/1 14/1 29/2 14/2 29/3 14/3 29/4 14/4 29/5* 14/5* 29/6* 14/6* 29/7* 14/7* 29/8* 14/8* Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...
  • Page 20 31/4 16/4 31/5* 16/5* 31/6* 16/6* 31/7* 16/7* 31/8* 16/8* 32/1 17/1 32/2 17/2 32/3 17/3 32/4 17/4 32/5* 17/5* 32/6* 17/6* 32/7* 17/7* 32/8* 17/8* Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...

  • Page 21: Related Documentation

    A complete list of all DSL product related documentation is available on the World Wide Web at http://www.cisco.com/univercd/cc/td/doc/product/dsl_prod/index.htm Obtaining Documentation The following sections provide sources for obtaining documentation from Cisco Systems. World Wide Web You can access the most current Cisco documentation on the World Wide Web at the following sites: http://www.cisco.com • http://www-china.cisco.com •...

  • Page 22: Obtaining Technical Assistance

    Technical Assistance Center The Cisco TAC website is available to all customers who need technical assistance with a Cisco product or technology that is under warranty or covered by a maintenance contract. Contacting TAC by Using the Cisco TAC Website...
  • Page 23 Scorecard, MGX, the Networkers logo, Packet, PIX, RateMUX, ScriptBuilder, ScriptShare, SlideCast, SMARTnet, TransPath, Unity, Voice LAN, Wavelength Router, and WebViewer are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, Discover All That’s Possible, and Empowering the Internet Generation, are service marks of Cisco Systems, Inc.; and Aironet, ASIST, BPX, Catalyst, Cisco, the Cisco...
  • Page 24 Obtaining Technical Assistance Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures OL-0991-01...