Wall-Mounting The Cisco Unified 500 Series (8- And 16-User Models Only) - Cisco Unified 500 Series Getting Started

Caution Do not place any items that weigh more than 10 lb (4.5 kg) on top of the chassis and do
not stack.
To install a chassis on a desktop, table, or other flat surface, place the unit upside-down on a flat
surface. Attach the four rubber pads to the recessed areas on the bottom of the unit. Place the unit on
a desktop.
Wall-Mounting the Cisco Unified 500 Series (8- and 16-user models
only)
You can mount the Cisco Unified 500 Series and power supply for the Cisco Unified 500 Series to a
wall or other vertical surface.
Warning This unit is intended to be mounted on a wall. Please read the wall mounting instructions
carefully before beginning installation. Failure to use the correct hardware or to follow
the correct procedures could result in a hazardous situation to people and damage to the
system. Statement 248
Attaching the Chassis and Power Supply to the Wall
The Cisco Unified 500 Series has two keyholes on the bottom of the chassis for mounting the unit on
a wall or other vertical surface. The power supply is mounted to the wall using the wall-mount bracket.
To mount the chassis and power supply on a wall, perform the following steps.
Tip When choosing a location for wall-mounting the router, consider cable limitations and wall
structure.
Step 1 Figure 6 shows the bottom of the Cisco Unified 500 Series and the locations of the wall-mount
holes.
21