SAC 3600 Series Operator's Manual page 49

VM900319 ELECTRICAL KIT
35
15
32
30
7 39 1
CONNECT TO 12 PIN RECEPTACLE
ON D03 VALVE STACK
CONNECT TO 2 PIN COIL
ON CONVEYOR MOTOR
PROPORTIONAL VALVE
NOTES:
1. ENSURE GOOD GROUND CONNECTION TO BATTERY.
2. CHECK THAT HARNESS VM700281 HAS THE CAN TEE INSTALLED NEAR THE
ROUND DEUTSCH CONNECTOR AND RESISTOR PLUG IS IN PLACE.
3. ROUTE THE POWER/GROUND AND CAN LEADS INTO THE CONTROL CONSOLE
AND CONNECT WITHIN THE CONSOLE.
4. TIE UP ANY EXCESS WIRES.
OPERATION
REPLACEMENT PARTS
USE HARDWARE PROVIDED
WITH VM800231 TO MOUNT
DISPLAY
INSTALL NOTED COMPONENTS IN THE
CONTROL CONSOLE PRIOR TO CONNECTING
WIRE HARNESSES.
14
37
NOTE: ELECTRIC BOX ENCLOSURE
CAN BE MOUNTED IN DIFFERENT DIRECTIONS
ON POST FOR BEST FIT PER CHASSIS.
38
CONNECT TO 4 PIN RECEPTACLE
ON CONVEYOR MOTOR
FORWARD/REVERSE VALVE
CONNECT TO 2 PIN RECEPTACLE
IN CAB FROM HARNESS VM700247
LABELED 'PWR/GND' FROM DISPLAY
18
CONNECT PLUGS
ROUTE CONNECTORS FROM
BOTH HARNESSES INTO THE
CONTROL PEDESTAL BOX FROM
THE REAR (CUTOUTS SHOWN)
CONNECT TO 4 PIN DTP
PLUG IN CAB FROM ELECTRIC
BOX VM900257 FOR POWER
21
CONNECT TO 3 PIN RECEPTACLE
IN CAB FROM HARNESS VM700247
LABELED 'CAN FROM ECU' FROM DISPLAY
READ complete manual CAREFULLY
Page # 49
35
17
11
CONNECT TO NEGATIVE
BATTERY POST
BEFORE attempting operation.
8
22