Table of Contents
Advertisement
SAFETY
DuRING OPERATION
• Use caution when working around the discharge area. Stay clear of the slide out discharge. This is
controlled from the cab and could operate without warning, creating pinch points which could cause severe
injury or death. Always stop engine before working close to the discharge area.
• Never attempt to release jammed materials or clean materials from any area of the mixer or discharge chute with
out stopping engine and disengaging drive line first. Moving parts can be hidden by materials, and stopped parts
can start unexpectedly, causing severe injury. Always stop truck engine and relieve hydraulic pressure before
attempting to remove jammed material or to clean.
• Never put arms or feet inside unit, power chute, or discharge door opening, nor climb on or in the mixer while it is
running. NEVER allow anyone to position themselves over or near the top of the mixer while it is running.
Rotating augers and sprockets can grab clothing or create pinch points which can cause severe injury or death
to the operator or bystanders. Always stop the engine so that the mixer can not be accidentally turned on while
inspecting, servicing, repairing, or cleaning the mixer.
FOLLOWING OPERATION
• Following operation, set brakes, shut off engine and remove the ignition key.
• Store unit in an area away from human activity.
• Do not park equipment where it will be exposed to livestock for long periods of time. Damage and livestock injury
could result.
• Do not permit children to play on or around stored unit.
• Make sure all parked machines are on a hard, level surface and engage all safety devices.
• Wheel chocks may be needed to prevent unit from rolling.
HIGHWAy AND TRANSPORT OPERATIONS
• Adopt safe driving practices:
-
Always drive at a safe speed relative to local conditions, ensure that your speed is low enough for an
emergency stop. Keep speed to a minimum.
-
Reduce speed prior to turns to avoid risk of overturning.
-
Do not drink and drive!
•
Comply with state and local laws governing highway safety on public roads.
•
Use approved accessory lighting, flags and necessary warning devices to protect operators of other vehicles on highway
during transport. Various safety lights and devices are available from your dealer.
•
Be a safe and courteous driver.
•
Be observant of bridge load ratings. Do not cross bridges rated lower than gross weight at which you are operating.
•
Make sure all the lights and reflectors that are required by the local highway and transport authorities are in place, are
clean and can be seen clearly by all overtaking and oncoming traffic.
•
Watch for obstructions overhead and side to side while transporting.
•
Always operate equipment in a position to provide maximum visibility. Make allowances for increased length and weight
of equipment when making turns, stopping unit, etc.
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
Page # 16
BEFORE attempting operation.
Advertisement
Table of Contents
