Table of Contents
Advertisement
Commissioning
The gas pressures of the appliance are factory preset for direct flue installations
(most common type of installation) and will normally not require adjustment. The
combustion chamber glass must be on when checking the operating pressures.
The commissioning sheet is located in a plastic
pouch inside the unit on the right hand side.
For all Evolve flueing EXCEPT direct flueing,
the appliance must be down rated as per the
instructions on the commissioning sheet.
Follow the commissioning instructions to
complete the gas pressure adjustments. When
commissioning is complete check for full and
correct operation of the appliance, and return
the commissioning sheet to its plastic pouch.
Check the Wi-Fi connection
Reconnect the power supply and observe the LED on the Wi-Fi board. The LED will blink red and
then turn a solid red when you plug the Wi-Fi into the PCB.
Connect the App. The LED will blink green and then turn a solid green when the Wi-Fi connects
to the home network. If unable to connect, the board must be reset. The reset button is a small
hole in the base of the board, underneath the LED. Using a paper clip or similar, press and hold
the reset button for 10 seconds. Once connected, guide the homeowner through the step by step
instructions on the App. The Wi-Fi App is available on:
•
Google play > search Rinnai Fire App
•
App store > search Rinnai Fire App
On initial startup the Wi-Fi module in the fire scans for a Wi-Fi
1
network, and if at first it doesn't work it will only scan again after ten
minutes.
24
| Evolve 952/1252 Installation Guide: 13115-E 05-19
Commissioning sheet—located inside a plastic pouch
inside the unit (right hand side)
1
2
1.
Wi-Fi LED
2.
Wi-Fi module reset hole position
Hide quick links:
Advertisement
Table of Contents
