Table of Contents
Advertisement
Check the Wi-Fi connection
When the power is on the Wi-Fi LED should flash and then turn a solid red to indicate everything is
ready for setup via a smart device
available, as part of the installation process is testing the Wi-Fi connectivity and correct operation
of the fire with the homeowner. The Wi-Fi app is available on:
Google Play > search Rinnai fire app
-
Apple app store > search Rinnai fire app
-
Summary of how the app works
1. Wi-Fi module in the fire, once installed and has power connected, is on.
2. Homeowner downloads the Rinnai Wi-Fi app on their smart device.
3. Through the app, the Wi-Fi in the fire links (pairs) to the homeowners smart device.
4. Homeowner, through the app setup process, then links the Wi-Fi in the fire to the Wi-Fi router
in the home—this essentially makes the smart device the fireplace controller.
If unable to connect, the Wi-Fi board must be reset by pressing down on the metal tab above the
Wi-Fi assembly on the unit. The image below highlights where the Wi-Fi assembly is positioned.
If this doesn't work switch the power off and then back on again to reset the fire—try a couple of
times if it doesn't work the first time.
Approximate position of the Wi-Fi module from the left hand side of the fire—where the On/Off
button is.
Wi-Fi reset position - A
800
265 mm
1000
350 mm
1500
650 mm
On initial startup the Wi-Fi module in the fire scans the Wi-Fi network, if at first it doesn't work it will only scan again after ten minutes.
1
28 | Linear installation guide 13563-H 08-19
. Go through the app sequence with the homeowner, if they are
1
Using a credit card or something similar
(non-metallic), press down to reset the Wi-Fi
module in the fire.
Advertisement
Table of Contents
