Controlling The Box Size And Position (Box Centred, Aspect Ratio On); Controlling The Box Size And Position (Box Not Centred, Aspect Ratio Off); Controlling The Box Size And Position (Box Not Centred, Aspect Ratio On) - evertz HD9690 Series Instruction Manual

3.7.3.4.

Controlling the Box Size and Position (Box centred, Aspect Ratio On)

Setup menu Force centre
Mode menu Aspect ratio
Or
Setup menu Force centre
Mode menu Aspect ratio
Mode menu Centre
Size When the box is centred and aspect ratio MODE is On, the left and right shaft encoders are
used to adjust the overall size of the box proportionately about the centre of the raster based
upon the aspect ratio selected.
3.7.3.5.

Controlling the Box Size and Position (Box not centred, Aspect Ratio Off)

Setup menu Force centre
Mode menu Aspect ratio
Mode menu Centre
When the box centering is Off and aspect ratio MODE is Off the sides of the box can be positioned
independently in one of four modes.
Size The left shaft encoder is used to adjust the height of the box, and the right shaft encoder is
used to adjust the width of the box about the centre of the box.
Position The left shaft encoder is used to adjust the vertical position of the box, i.e. move the box up or
down, and the right shaft encoder is used to adjust the horizontal position of the box, i.e. move
the box left or right.
H no track The left shaft encoder is used to adjust the left side of the box and the right shaft encoder is
used to adjust the right side of the box.
V no track The left shaft encoder is used to adjust the top of the box and the right shaft encoder is used to
adjust the bottom of the box.
3.7.3.6.

Controlling the Box Size and Position (Box not centred, Aspect Ratio On)

Setup menu Force centre
Mode menu Aspect ratio
Mode menu Centre
When the box centering is Off and aspect ratio mode is On the position and overall size of the box can be
adjusted proportionately about the centre of the box based upon the aspect ratio selected.
Position The left shaft encoder is used to adjust the vertical position of the box, i.e. move the box up or
down and the right shaft encoder is used to adjust the horizontal position of the box, i.e. move
the box left or right.
Size The left shaft encoder is used to adjust the size of the box with the bottom right corner fixed.
The right shaft encoder is used to adjust the size of the box with the top left corner fixed.
FRONT PANEL OPERATION
HD9690 Series HDTV Graticule Generator Manual
Yes
1:1 4:3 14:9 16:9
No
1:1 4:3 14:9 16:9
H + V
no
off
off
No
1:1 4:3 14:9 16:9
off
Revision 1.5
1.67:1 1.85:1 2.35:1
1.67:1 1.85:1 2.35:1
1.67:1 1.85:1 2.35:1
Page 3-23