Table of Contents
Advertisement
HD9690 Series HDTV Graticule Generator Manual
3.6.3. Controlling the Cursor Attributes
When the cursor object is selected the CTRL SEL button is used to select which of its attributes (colour.
line width, position, or size) will be adjusted by turning the shaft encoder knobs. Press the CTRL SEL
button until the desired CTRL SEL item is shown on the front panel. When you have chosen the desired
CTRL SEL item press the CURSOR button again or turn one of the shaft encoder knobs to begin
controlling the selected attribute of the cursor. The selected attribute for control will show on the ctrl line of
the OSD.
3.6.3.1.
Controlling the Cursor Colour
Colour
The colour of the cursor object can be adjusted in the range of "0" through "14", in single digit
increments, using either shaft encoder. The colours that will be displayed for each value are
shown in Table 3-2.
3.6.3.2.
Controlling the Cursor Line Width
Line Width
3
Line Width
The line width of the cursor object can be adjusted in the range of "3" through "11", in
increments of two, using either shaft encoder. Only the pixels (lines) in the centre of the line
width are keyed at 100%. The edges of the line are keyed at a reduced level to reduce
aliasing.
3.6.3.3.
Controlling the Cursor Size
Size
The size of the cursor can be adjusted using either of the shaft encoders. The size will change
proportionately about the centre of the cursor.
H/V Size The left shaft encoder is used to adjust the height of the CURSOR vertical line, and the right
shaft encoder is used to adjust the width of the cursor horizontal line.
3.6.3.4.
Controlling the Cursor Position (Cursor not centred)
Mode menu
Centre
When the cursor centering is Off the position of the cursor can be adjusted.
Position The left shaft encoder is used to adjust the vertical position of the cursor, i.e. move the cursor
up or down and the right shaft encoder is used to adjust the horizontal position of the cursor,
i.e. move the cursor left or right.
3.7.
CONTROLLING THE BOX OBJECTS
There are two box objects, called box1 and box2.
independently, and operate the same way. Often box1 is used to mark the safe action area and box2 is
used to mark the safe title area. References throughout this section to the box object apply to either box1
or box2. The box perimeter lines are shaped to avoid sharp transitions in the video. Line width may be
adjusted using the Line Width attribute. The locations of the box perimeter lines shown is the centre of the
line.
Page 3-20
5
7
off
Revision 1.5
9
11
Each of the box objects can be controlled
FRONT PANEL OPERATION
Advertisement
Table of Contents
