Installing The Fork Legs - Husqvarna FC 450 Rockstar Edition 2022 Owner's Manual

11.12

Installing the fork legs

SERVICE WORK ON THE CHASSIS 11
–
Loosen screws
–
Loosen screws
A01068-10
Main work
–
Position the fork legs.
Air bleeder screw
the front.
A
Valve
Info
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
F03665-11
must be flush with the upper edge of the upper triple
clamp.
The air suspension is located in the left fork leg. The
pressure and rebound damping is located in the right
fork leg.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
A01068-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Position the brake line and the clamp. Mount and tighten
5
screws .
F03657-11
Finishing work
–
Install the front wheel.
3
. Remove the left fork leg.
4
. Remove the right fork leg.
1
of the right fork leg is positioned to
of the left fork leg faces the front.
2
.
M8 17 Nm (12.5 lbf ft)
3
.
M8 12 Nm (8.9 lbf ft)
M8 25 Nm (18.4 lbf ft)
( p. 96)
4
.
®
Loctite 243™
53