Jumpers And Local Contols; Selecting Whether Local Faults Will Be Monitored By The Global Frame Status; Configuring The Module For Firmware Upgrades - evertz 7700 Multiframe Manual

5.

JUMPERS AND LOCAL CONTOLS

Several jumpers, located at the front of the module, are used to preset various operating modes. Figure
4-1 shows the locations of the jumpers.
5.1. SELECTING WHETHER LOCAL FAULTS WILL BE MONITORED
BY THE GLOBAL FRAME STATUS
The FRAME STATUS jumper determines whether local faults (as shown by the Local Fault indicator) will
be connected to the 7700FR frame's global status bus.
FRAME STATUS: To monitor faults on this module with the frame status indicators (on the Power
Supply FRAME STATUS LED's and on the Frame's Fault Tally output) install this
jumper in the On position (default)
When this jumper is installed in the Off position local faults on this module will not
be monitored.
5.2.

CONFIGURING THE MODULE FOR FIRMWARE UPGRADES

UPGRADE: The UPGRADE jumper is used when firmware upgrades are being done to the
module. For normal operation it should be installed in the RUN position (see NOTE
1 below). See the Upgrading Firmware section of this manual for more information.
To upgrade the firmware in the module unit pull it out of the frame. Move the
UPGRADE jumper into the UPGRADE position (see NOTE 1). Install the Upgrade
cable provided (located in the vinyl pouch in the front of this manual) onto the
SERIAL header at the card edge. Re-install the module into the frame. Run the
upgrade as described in the Upgrading Firmware section of this manual. Once the
upgrade is complete, remove the module from the frame, move the UPGRADE
jumper into the RUN position, remove the upgrade cable and re-install the module.
The module is now ready for normal operation.
7707OE-3G-1 3G/HD/SDI Re-Clocking Optical to Electrical Converter
Revision 1.0
7700 MultiFrame Manual
Page-13