Status Indicators And Displays; Status Indicator Leds; Figure 4-1: 7707Oe-3G-1 Status Indicator And Jumper Locations - evertz 7700 Multiframe Manual

7700 MultiFrame Manual
7707OE-3G-1 3G/HD/SDI Re-Clocking Optical to Electrical Converter
4.

STATUS INDICATORS AND DISPLAYS

The 7707OE-3G-1 has 3 LED Status indicators and a 4 digit alphanumeric display on the front card edge
to show operational status of the card at a glance. The card edge pushbutton is used to select various
displays on the alphanumeric display. Figure 4-1 shows the location of the card edge status indicators,
dot matrix display, pushbutton and jumpers.

Figure 4-1: 7707OE-3G-1 Status Indicator and Jumper Locations

4.1.

STATUS INDICATOR LEDS

LOCAL FAULT: This Red LED indicates poor module health and will be On during the absence of a
valid input signal or if a local power fault exists (i.e.: a blown fuse). The LOCAL
FAULT indication can also be reported to the frame through the FRAME STATUS
jumper.
MODULE OK: This Green LED indicates good module health. It will be On when a valid input
signal is present, and the board power is good.
VIDEO STATUS: This LED indicates the status of the optical input video signal. When a valid input
video signal is detected the LED will be green. The LED will be yellow if Bypass
Mode is selected. If no video is detected on the optical input of the 7707OE-3G-1
the LED will remain off.
Page-8
Video Status
FRAME STATUS
ON/OFF
LOCAL FAULT
/ MODULE OK
UPGRADE
RUN/UPGRADE
Revision 1.0