Table of Contents
Advertisement
7.4
Key functions
Your Proline Thermostat is easy to operate.
7.4.1 General key functions and pilot lamps
Master
or
...
EXT
30
The timer continues to run. Stop as required with
Enter key:
From the actual-value display at the main menu level,
activates input, display flashes,
saves input, display ceases to flash and menu point is left,
press for approx. 3 s: Exit function and returns to bath temperature
display.
Paging with keys is possible within the relevant level,
or setting of numerical values
Speeds up entry by moving the counting position to the left:
a) Keys are pressed and held down or
b) One of the two keys is pressed and held down, followed immediate-
ly by brief pressing of the other key.
Moves counting position to the right:
Switching one place to the right occurs by briefly (1 s) releasing
the key, followed by another pressing of the key.
Useful additional information:
Two dots in the Master display indicate that a submenu follows.
°C
Three dots in the display indicate that a submenu for a module (in-
terface...) or a component (thermostat, Command remote control
....) follows. Module/component-specific possible settings are only
displayed when the hardware is connected.
The following always applies: After termination of the relevant
settings, they are accepted automatically after approx. 4 s or
the setting is accepted immediately with the Enter key.
Fault signal: Flashing red Alarm LED and acoustic signal.
An acoustic signal can only sound when it has not been intentionally
and
deactivated! ( 7.8.6)
The bath control occurs via the external temperature probe when
the green LED is lit.
Heating is active when the yellow LED is lit.
Cooling is active. When the setpoint temperature is lowered, it
makes take up to one minute before the blue LED is lit.
The temperature of the external probe is displayed.
Proline Edition X heating thermostats
Starting up
Pause
( 7.12).
YACE0099 / 10/9/2018
Advertisement
Table of Contents
