Activating External Control - Lauda PROLINE Edition X P 5 C Operating Instructions Manual

Command
Pump level
Pump Menu

7.7.4 Activating external control

An external temperature probe can be connected to the Proline Thermostats. How this is done is ex-
plained in Section 7.7.2. If the set point temperature is to be controlled using this sensor instead of the
internal sensor, the setting can be made here.
Furthermore, control can also occur based on the signal from the analog or serial module ( 4.8).
Master
and 2 x
Con 1
42
Level 8
Level 7
Level 6
Level 5
Level 4
Level 3
Level 2
Level 1
End T
+
Please exercise caution when thermostat is in standby mode.
The following settings/ actions may start the thermostat unintentionally from the standby
mode:

A previously activated timer mode ( 7.12), because a started time continues
to run.
 "Start" command via interfaces ( 8).
Con
Call the source selection for the control
 The momentary setting for the source is displayed,
 here
°C
ature signal from the internal temperature probe.
 The source display flashes.
Proline Edition X heating thermostats
Pump level
 Open the device parameter menu via the
 Change from
 With
 Select another pump level with
T
 or quit the window with
set fix
Standby activation
 Standby activation
1
for internal, because control takes place using the temper-
Starting up
soft key Menu .

Pump
ing .
or you enter the illustrated
window. Level 5 is active.
and confirm with or End ,
any changes.
(Pump and heater are deactivated when
the green LED in the lower part of the key
is lit).
Con
.
Pump level us-
or
without making
YACE0099 / 10/9/2018