Table of Contents
Advertisement
7.3
Switching off / standby
Switching off: Set mains switch to position 0. With operation at temperatures below 0 °Celsius only
switch off the device via standby, because otherwise severe condensation and dew formation can
occur.
Standby operation: Use the key
the master display. The pump, heating and cooling unit are switched off, but the operating display and
the electrical bath bridge heating for RP 890 C and RP 1290 C remain active, so that dew formation and
condensation into the bath continue to be suppressed.
7.4
Key functions
Your Proline Thermostat is easy to operate.
7.4.1 General key functions and pilot lamps
Master
or
...
28
on the command console or by selecting the pump level Zero on
However, a started timer ( 7.12) continues to run. Stop as required with Pause.
Enter key:
From the actual-value display at the main menu level,
activates input, display flashes,
saves input, display ceases to flash and menu point is left,
press for approx. 3 seconds: Exit function and returns to bath
temperature display.
Paging with keys is possible within the relevant level,
or setting of numerical values
Speeds up entry by moving the counting position to the left:
a) Keys are pressed and held down or
b) one of the two keys is pressed and held down, followed
immediately by brief pressing of the other key.
Moves counting position to the right:
Switching one place to the right occurs by briefly (1 second)
releasing the key, followed by another pressing of the key.
Useful additional information:
Two dots in the Master display indicate that a submenu follows.
°C
Three dots in the display indicate that a submenu for a module
(interface...) or a component (thermostat, Command remote
control....) follows. Module/component-specific possible settings
are only displayed when the hardware is connected.
Proline Edition X cooling thermostats
Starting up
YACE0100 / October 4, 2018
Hide quick links:
Advertisement
Table of Contents
