Fujitsu ETERNUS SF Express V16.6 Migration Manual page 377

7.
If the upgrade completes successfully, the following message is displayed.
INFO: ETERNUS SF was installed successfully.
8.
Change to a directory other than the DVD-ROM.
Example:
# cd
9.
Unmount the DVD-ROM.
Example:
# umount /mnt/dvd
10.
Remove the DVD-ROM used for the Upgrade Installation from the device.
The upgrade is complete above.
Return to the section where this item was referenced to continue tasks.
C.8.2 Performing Upgrade with Silent Installation Procedure
The procedure of the silent upgrade installation of Solaris / Linux Edition AdvancedCopy Manager Copy Control Module are as listed
below.
1.
Insert the "ETERNUS SF SC / ACM Media Pack (Solaris Edition) Manager Program (2/2)" or "ETERNUS SF SC / ACM / Express Media
Pack (Linux 64bit Edition) Manager Program (2/2)" DVD-ROM of this version level into the DVD-ROM drive.
Refer to "Configuration of the DVD-ROM" of the ETERNUS SF Installation and Setup Guide for the configuration and the stored
contents of the DVD-ROM.
2.
Mount the DVD-ROM.
Example:
# mount /mnt/dvd
3.
Execute the following silent installation command.
For installLogFile, specify the file in which to output installation log with an absolute path. It is optional to specify for
installLogFile.
# <dvdromMountPoint>/Manager_unix/esfsilentinstall_ccm.sh -eula agreed [-l <installLogFile>]
Point
-
The -eula option is specified to agree to licensing. Only when "agreed" is specified for option parameter is installation
enabled. The -eula option must be specified before other options.
-
If nothing is specified for installLogFile, an install log file named "esfsilentinstall.log" is created in the /var/tmp directory.
-
If there is any file of the same name as the specified install log file, it is overwritten.
-
It is required to specify an existing directory with write permission for the directory in which to store the install log file. If it
has no write permission, no error message is output in the command prompt or screen and the process terminates with error.
-
If the paths to the install log file contain any spaces, they should be surrounded by double quote characters.
-
The characters " ! $ are not supported for path name for install log file.
Note
-
If an invalid option is specified, its corresponding error message is output in the install log file and the process exits. No error
message is output in the command prompt or screen.
- 353 -