Fujitsu ETERNUS SF Express V16.6 Migration Manual page 225

Chapter 10
To upgrade AdvancedCopy Manager's manager to this version, install the ETERNUS SF Manager.
If performing an upgrade to a system environment using Agent-based operation model, perform the upgrade in the following
sequence.
1.
AdvancedCopy Manager's manager
2.
AdvancedCopy Manager's agent
For the upgrade, there is a method where the upgrade is performed in an interactive format and a method where the upgrade is
performed using a command for silent installation without the need of responses (silent installation procedure).
The operating environment that supports the upgrade with the silent installation procedure is as follows:
-
Windows Server 2008 or later
-
Solaris
-
Red Hat Enterprise Linux 5, Red Hat Enterprise Linux 6, Red Hat Enterprise Linux 7, and SUSE Linux Enterprise Server 12
Point
-
In the version level of the AdvancedCopy Manager, there are conditions for the combination of manager and agent. Upgrade your
version, in order to fulfill the combination that is described in "Notes on Combining Different Versions" of the ETERNUS SF Release
Guide.
-
If Storage Cruiser and AdvancedCopy Manager Copy Control Module are both installed on the same server, when upgrading, both
Storage Cruiser and AdvancedCopy Manager Copy Control Module are upgraded at the same time. Therefore, perform backups of
the previous versions before starting the upgrade.
-
It is possible to perform an Upgrade Installation with existing Advanced Copy and Remote Advanced Copy sessions. Regardless of
whether there are Advanced Copy sessions or not, the upgrade procedure is the same.
10.1 Upgrading AdvancedCopy Manager's Manager (for Windows)
10.1.1 Upgrading on Non-clustered Systems
10.1.1.1 Preparing for Upgrade
Point
It is recommended that you back up the system before starting the upgrade.
By preparing a backup, in cases when an error occurs during the upgrade, it is possible to return the system to its state prior to the
upgrade, simply by recovering (restoring) the system from the backup.
1.
Log on to the server using Administrator privileges.
2.
Ensure that there is enough available disk space (400 MB) on the server where the upgrade is performed.
In cases when upgrade installation is executed in a state where the capacity required for the upgrade is not available, the
following message is displayed and the installation terminates in an error. Re-execute the upgrade after securing the capacity
required for the installation.
[Output message (when the drive letter of the destination of the installation is C)]
The available capacity of the specified disk (C:) is insufficient. Please execute it again after
increasing the disk area.
3.
If the Storage Cruiser's agent has been installed, stop the service of the Storage Cruiser's agent. Refer to "Starting and Stopping
Agent" in the ETERNUS SF Storage Cruiser Operation Guide for information on how to stop the service.
Upgrade from AdvancedCopy Manager Version 16.x
- 201 -