Fujitsu ETERNUS SF Express V16.6 Migration Manual page 213

9.6.2 Upgrading on Clustered Systems
The following values are used in the description:
Value
$INS_DIR
9.6.2.1 Preparing for Upgrade
Point
It is recommended that you back up the system before starting the upgrade. If a failure occurs during the upgrade, you cannot restore
the environment to the pre-installation status (rollback).
When returning back to the state before installation of the upgrade, recover (restore) the system from the backup.
1.
Log on to the server using Administrator privileges.
2.
Check that the CCM Server transactions are stopped on the secondary node.
If not stopped, use the Failover Cluster Manager on the secondary node to stop the transactions of AdvancedCopy Manager Copy
Control Module.
3.
Stop the CCM Server transactions on the primary node.
Use the Failover Cluster Manager to stop the transactions of AdvancedCopy Manager Copy Control Module.
However, the shared disk for shared data of AdvancedCopy Manager Copy Control Module must be online.
4.
On the primary node, perform a backup of the operating environment of the previous version of the AdvancedCopy Manager Copy
Control Module.
Note that the capacity required for performing this backup is 100 MB.
a.
Log on to the server using Administrator privileges.
If already logged on as the Administrator privileges, this step is unnecessary.
b.
Insert the DVD-ROM "ETERNUS SF SC/ACM/Express Mediapack for Windows (Manager Program) (1/2)" for this version into
the DVD-ROM drive.
Refer to "DVD-ROM Contents" in the ETERNUS SF Installation and Setup Guide for this version for information on the DVD-
ROM structure and detailed contents.
c.
Implement backup of the previous version.
Execute the following batch file. For backupDir, specify the directory in which to store the backup data with an absolute
path.
dvdromDrive:\Manager_windows\vuptools\esfccmpreinst_cluster.bat backupDir -primary
When the backup fails, after confirming the output error message and removing the cause of the failure, execute the batch
file again.
Point
-
Spaces and the characters " | : * ? / . < > , % & ^ = ! ; ( ) are not supported for directory name.
-
The number of characters in a directory name must be up to 220.
d.
Eject the DVD-ROM.
5.
Checking for available disk space
Ensure that there is enough available disk space on the server where the upgrade is performed.
The required disk space for the upgrade is calculated as the "Required Disk Space for New Version" minus the "Required Disk Space
for Previous Version".
"Program Directory" specified at the AdvancedCopy Manager CCM installation.
Description
- 189 -