Performing Upgrade; Tasks To Be Performed After Upgrade - Fujitsu ETERNUS SF Express V16.6 Migration Manual

the following message is displayed and the installation terminates in an error. Re-execute the upgrade after securing the
capacity required for the installation.
Output Message (in cases when the directory of the destination of the installation is /opt):
ERROR:Disk /opt has an insufficient free space. Please execute it again after increasing the disk
area.
3.
Execute the following command to stop the ETERNUS SF Manager daemon.
# /opt/FJSVesfcm/bin/stopesf.sh
4.
When upgrading from Version 16.2 or earlier on the Linux environment, uninstall the FJSVswstt package (SNMP Trap daemon
package).
Execute the following command to check whether the FJSVswstt package is installed.
# rpm -q FJSVswstt
If the FJSVswstt package information is displayed, execute the following command to uninstall the FJSVswstt package.
-
For Red Hat Enterprise Linux 7
# systemctl stop startsc-snmptrapd.service
# systemctl disable startsc-snmptrapd.service
# rm /usr/lib/systemd/system/startsc-snmptrapd.service
# rpm -e FJSVswstt
-
For Red Hat Enterprise Linux 5 or Red Hat Enterprise Linux 6
# rpm -e FJSVswstt
7.2.1.2

Performing Upgrade

Refer to "C.4 Procedures for Upgrade Installation of Manager Feature of Express / Storage Cruiser / AdvancedCopy Manager Version 16.x
(for Solaris, Linux)" and perform the Upgrade Installation.
Point
If the Upgrade Installation has ended in an error, after removing the cause of the failure of the Upgrade Installation, re-execute the
installation from the execution of the installation shell.
7.2.1.3

Tasks to Be Performed After Upgrade

The tasks below need to be performed.
1.
In the version level of this ETERNUS SF Manager, Symfoware is not used.
To upgrade from Version 16.1 or later, the procedures listed below are not needed.
To upgrade from Version 16.0 or earlier, follow the procedures listed below to uninstall the Symfoware Server.
a.
Confirm that other products are not utilizing the Symfoware. If Symfoware is in use by another product, refrain from
uninstalling Symfoware.
b.
Start the uninstaller of Symfoware to delete the Symfoware package.
# /opt/symfoware/setup/symfo_remove
c.
Confirmation message to uninstall Symfoware is displayed.
To perform the uninstallation, enter "y". To cancel the process, enter "q".
When "y" is entered, a message allowing to select the function to uninstall is shown. Input "all" or "number to delete" to
- 96 -