Fujitsu ETERNUS SF Express V16.6 Migration Manual page 273

2.
Recover the original environment configurations file (sys.properties) of the AdvancedCopy Manager CCM.
Overwrite the original environment configurations file onto the file of the copying destination.
Original Environment Configurations File
$INS_DIR\CCM\noncluster\sys\sys.properties
3.
Save the general script for the AdvancedCopy Manager CCM.
In corresponding previous version of "Preparing General Scripts for AdvancedCopy Manager CCM" corresponding to each OS and
nodes in the ETERNUS SF Cluster Environment Setup Guide, in cases when the general scripts have been stored under the bin
directory of the program directory of the AdvancedCopy Manager CCM, make a copy on any directory that is other than the
directory which is the destination of the installation of AdvancedCopy Manager CCM.
The saved file is used in tasks after the upgrade.
4.
Refer to "C.7 Procedures for Upgrade Installation of AdvancedCopy Manager Copy Control Module Version 16.x (for
perform the upgrade.
5.
The shared disk for shared data of AdvancedCopy Manager Copy Control Module must be offline.
Point
If the Upgrade Installation has ended in an error, refer to
Windows)" and return the system to a normal state.
10.6.2.3 Performing Upgrade (Secondary Node)
1.
The shared disk for shared data of AdvancedCopy Manager Copy Control Module must be online.
2.
Perform the upgrade for the secondary node.
The upgrade procedure is the same as that for the primary node. Refer to
3.
The shared disk for shared data of AdvancedCopy Manager Copy Control Module must be offline.
Point
If the Upgrade Installation has ended in an error, refer to
Windows)" and return the system to a normal state.
10.6.2.4 Tasks to Be Performed After Upgrade (Primary Node)
The tasks below need to be performed on the primary node.
The shared disk for shared data of AdvancedCopy Manager Copy Control Module must be online.
1.
Restore the environment setting files (sys.properties) for AdvancedCopy Manager Copy Control Module
Overwrite the environment configurations file (sys.properties) saved in
following file after upgrade installation.
The environment setting files for AdvancedCopy Manager Copy Control Module is as follows.
$INS_DIR\CCM\sys\sys.properties
2.
Restore the saved general scripts for the AdvancedCopy Manager CCM.
When general scripts are backed up in
the directory stored in "Preparing General Scripts for AdvancedCopy Manager CCM", which corresponds to respective operating
systems and nodes described in the ETERNUS SF Cluster Environment Setup Guide of the appropriate earlier version.
10.6.2.5 Tasks to Be Performed After Upgrade (Secondary Node)
Tasks that are required after installing the upgrade of the secondary node are the same as with the primary node. Refer to
Tasks to Be Performed After Upgrade (Primary
Copying Destination File
$INS_DIR\CCM\sys\sys.properties
"11.3.1 In Case of Problem During Upgrade of ETERNUS SF Manager (for
"11.3.1 In Case of Problem During Upgrade of ETERNUS SF Manager (for
"10.6.2.2 Performing Upgrade (Primary
Node)".
- 249 -
"10.6.2.2 Performing Upgrade (Primary
"10.6.2.2 Performing Upgrade (Primary
Node)", restore the backed-up general scripts to
Windows)" to
Node)".
Node)" onto the
"10.6.2.4