Chapter 3 Configuring The 2085-It8-Sc/It16-Sc Using Ccw; Section 3.1 Introduction - Spectrum Controls Micro800 2085-IF16C-SC User Manual

I-1 Index
Section 3.1
Introduction
Chapter 3
Configuring the 2085-IT8-
SC/IT16-SC Using CCW
This chapter covers how to use Connected Components Workbench (CCW) and
optionally ModuleConfigConverter.exe software to configure the Module.
You use CCW software (v 9.00.00 and above) to configure the 2085-IT8-SC and
2085-IT16-SC Expansion I/O Modules. Spectrum Controls, Inc. provides a
custom configuration software utility that you may use to provide configuration
settings to the profile. You then send the configuration setup to the module.
Your controller firmware must be at v. 9.011 and above as well.
The Micro850/870 Controller (Bus master) subsystem is located at the left end of
the bus. This subsystem is comprised of:
Micro800 Controller
•
Micro800 Plug-in I/O Modules
•
2085-ECR Bus Terminator
•
Optional:
• 2080-PS120-240VAC Power Supply (separate module or built-in the
main controller).
2080 Expansion Modules
•
2085-EP24VDC Expansion Power Supply for Micro870 Controller with
•
more than four 2085 Expansion I/O Modules installed.
User's Manual Pub. 0300322-01 Rev. B