Table of Contents
Advertisement
Overview
•
Other diagnostics
System Utility Controls
•
Chamber Lights: To turn the print chamber's interior lights on/off, tap the button with the
lightbulb icon.
•
Calibration: This button is used to calibrate the build platform. For more on calibration, see
Section 7.1.
•
Project Light Engine: Two buttons can be selected here: Project Full Area and Project Test
Pattern. Tapping Project Full Area will cause the projector to illuminate its maximum area
which can be used to check function or during troubleshooting. Tapping Project Test
Pattern will display a test pattern which can be used to check the focus of the projector.
•
Print Heating: The slider bars here allow you to adjust the heat settings for the chamber
heater as well as the interface glass heater.
Figure 3: System Settings screen
System utility
controls
© Copyright 2022 Stratasys. All rights reserved.
System Settings
Page 17
Advertisement
Table of Contents
Troubleshooting
