Stratasys Origin One User Manual page 40

Basic User Operations
8. Use one hand to apply firm downward pressure on the build head while using the other
hand to tighten the calibration bolt with the 10 Nm torque driver. While tightening the
calibration bolt, ensure that the build head surface remains in close, even contact with the
midplate glass.
9. Tighten the calibration bolt slowly until a click is heard and felt.
Figure 11: Complete calibration step 2
Figure 12: Complete calibration step 3
© Copyright 2022 Stratasys. All rights reserved.
Pre-Print Procedures
Page 33