Table of Contents
Advertisement
Basic User Operations
2. Place the build head with attached part(s) on a tray and carry it over to the part staging/
cleaning area.
Detaching Printed Parts
1. Using a razor blade or small scraper, firmly and carefully scrape along the face of the build
head to remove the printed part(s). Increase pressure until the part separates from the build
Using a tray to transfer the build head to the cleaning area is not required, but will
prevent any uncured resin from dripping onto unwanted areas.
© Copyright 2022 Stratasys. All rights reserved.
Figure 22: Build head with parts
Post-Print Procedures
Page 43
Advertisement
Table of Contents
Troubleshooting
