Tray Maintenance
Required Tools
•
Nitrile goloves
•
4mm hex 4Nm T-handle driver
•
Resin tray thumbscrew
Procedure
1. Using a 4mm hex 4Nm T-handle driver, remove 8 screws from the bottom of the tray.
Warning: Skin contact hazard
Prolonged contact with solvents can cause skin irritation. Do not continue before
putting on protective gloves.
© Copyright 2022 Stratasys. All rights reserved.
Figure 6: Tray and tools
Replacing Tray Sheets
Page 57