Bandit INTIMIDATOR 15XP/1390 Operating & Parts Manual page 97

MODEL 15XP/1390
TYPICAL HYDRAULIC RELIEF PRESSURE SETTINGS
TYPICAL HYDRAULIC FLOWS AND RPM SETTINGS
(Approximate, For Reference Only, Engine At Full RPM)
Equipment
GPM (LPM)
Top Feedwheel
GPM (LPM)
Bottom Feedwheel
GPM (LPM)
Feedwheel
Main Relief PSI
Feed Relief
Yoke Relief
Winch Relief
Discharge Rotate
Discharge Flipper
Front Stabilizer
NOTICE
DO NOT UNDER ANY CIRCUMSTANCES OVER-SET THESE RELIEF PRESSURES, BECAUSE IT WILL
CAUSE DAMAGE TO COMPONENT PARTS AS WELL AS HYDRAULIC PARTS.
NOTICE
These typical hydraulic flows and relief pressure settings are with the engine at full RPM. All settings are
subject to change!
CAUTION
!
After the initial start‑up of the machine and after any replacement of hydraulic components, that fittings
and hoses should be re-checked for leaks and clearances.
Copyright 9/18
HYDRAULICS
15XP/1390
Model
Pump
10.2 (38.6)
5.1 (19.3)
5.1 (19.3)
35 - 37
RPM
2500 (172)
(bar)
2500 (172)
PSI (bar)
1500 (103)
PSI (bar)
2200 (152)
PSI (bar)
500 - 800
PSI (bar) (34 - 55)
500 - 800
PSI (bar)
(34 - 55)
2200 (152)
PSI (bar)
15XP/1390 Track
FEED
10.2 (38.6)
5.1 (19.3)
5.1 (19.3)
35 - 37
FEED
2500 (172)
2500 (172)
UP
2100 (145)
2200 (152)
900 (62)
800 (55)
N/A
81
HYDRAULICS
TRACK
23.4 (88.6)
TRACK
3500 (241)
DOWN
1500 (103)
Bandit