Bandit INTIMIDATOR 15XP/1390 Operating & Parts Manual page 179

Table of Contents

Advertisement

BANDIT CONTROLS
Program Notes
Display
- If Controller 1 (C1) loses communication with the Display, C1 will default to Radio mode.
- If C1 loses comm with the Display AND the radio receiver, it will default to Tether Mode.
- If C1 loses comm with display and receiver and tether, it will remain in Manual mode internally.
Radio (Rx=receiver; Tx=Transmitter)
- If C1 loses comm with receiver, all messages zeroed/centered
- BadCount03: RadioEStop (counts only while in Radio Mode)
Tether
- In order to Feed Fwd must have RPM above AutoFeed Hi or be in AutoFeed Bypass
- Things that will automatically disengage Feed Fwd:
- Change the machine mode away from Tether to Radio or Manual
- Lose comm with either Tether keypad while in tether mode
- RPM command goes below AutoFeed Lo setting (make sure AutoFeed Hi is not set higher than Engine
Hi Speed).
- Winch un-stowed will stop Feed Fwd and make it Feed Assist
Engine
- Critical engine faults related to Tier4 DPF soot levels:
- these faults will trigger the engine to idle down and request action from the operator
- engine may also derate or shutdown in severe cases
SPN
FMI
3251
0 cu DPF is full of soot. Contact engine service center.
3251
16 cu DPF is nearly full of soot. Goto MENU - DPF and Force a Regen.
3703
31 ca DPF is nearly full of soot. Goto MENU - DPF and Force a Regen.
3714
31 ca DPF is nearly full of soot. Goto MENU - DPF and Force a Regen.
3715
31 ca DPF is full of soot. Contact engine service center.
3719
0 ca jd DPF is full of soot. Goto MENU - DPF and Force a Regen. Contact service center.
3719
15 jd DPF is nearly full of soot. Goto MENU - DPF and Force a Regen.
3719
16 ca jd DPF is nearly full of soot. Goto MENU - DPF and Force a Regen.
- C1 will idle Eng down for
- Key to start position
- C1 loses comm with Eng
- RadioMode and RxComm Good and TxComm Bad (Tx out of range, Tx OFF, Tx batteries low)
- RadioMode and RxComm Bad
- TetherMode and Tether Comm bad
- DPF DTC's
- Push 'Force' in Maint2-DPF
- Manual Mode and Lost Display
- FuelSaver is shut off when Eng RPM is below AF Hi setting
Feed
- When you throttle down while feeding fwd, Feed Fwd will drop out and AutoRev will fire one time (within
6sec).
245774458290 21Dec2016
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents