Bandit INTIMIDATOR 15XP/1390 Operating & Parts Manual page 163

BANDIT CONTROLS
Maint Pages
MAINT4 RADIO
The radio and tether systems (optional on some machines) send all
of their signals via CAN messages and therefore cannot be checked
physically at the receivers with a voltmeter. This Maintenance
screen is a tool used to function check all inputs coming from the
radio and tether keypads to ensure they are working properly. With
the ignition ON but ENGINE NOT RUNNING, work through each
button on the radio and tether and make sure the corresponding
values change. The numbers shown are raw values that the program
translates into commands.
The number close behind
descriptions is an error count.
(If Fuel Saver mode is turned on and the machine idles down
due to light load conditions, simply press Throttle Up and then
press Feed Fwd to resume feeding).
(If the Winch Stow Switch indicates that the winch is out, Feed
Fwd will stop automatically and the Radio Winch functions will
be enabled. The Radio Feed Fwd button then can be used to
Feed Assist on Electric Feed Assist machines. Once the Winch
is properly stowed, Radio winch functions will be disabled and
Feed Fwd will operate as normal to resume chipping).
The Yoke/Lift is disabled while winch is deployed. Except,
Yoke/Lift can momentarily operate with Feed-Assist-Fwd.
Yoke/Lift is fully enabled again once the winch is properly
stowed tight on the stow bar.
When the mechanical control bar is in the reverse position a
switch interrupts the FeedRev coils to prevent a double reverse
which would then feed forward.
245774458290 21Dec2016
E-Stop, Rx to C1, and Tether
Input values change from 0 to 1 when
that Radio function is active.
Error counts for how many times the
controller has lost comm with the
receiver or transmitter.
7