Bandit INTIMIDATOR 15XP/1390 Operating & Parts Manual page 70

MODEL 15XP/1390
# DESCRIPTION
1 Chipper Bearings
2 Feedwheel Bearings
3 Hood Hinge
4 Feedwheel Slide Box
Steel Friction Areas: pivoting,
5
hinged, sliding, rolling
6 Chain Driven Components
7 Pintle Eye Ring
8 Bandit Throttle Cable
9 Discharge Swivel Plates
10 Clutch
11 Wheel Bearings - if equipped
12 Tracks - if equipped
5
Use as a reference only, locations may vary depending on options or component manufacturer.
NOTICE
Lubrication point instructions are described on the machine, in the Lubrication & Coolant
Section and Maintenance Section of this manual, or component manufacturer's manual.
Copyright 9/18
LUBRICATION CHART
DAY WEEK MONTH PROCEDURE
X
X
X
X
A right angle grease fi tting may need to be used to grease some of the lubrication
points. This type of grease fi tting can be obtained from most local automotive
parts stores.
5
5
CHECK
Purge ‑ wipe off excess
1 shot of grease ‑ wipe off excess
1 ‑ 2 shots of grease ‑ wipe off excess
Clean and oil with 10W/30
Lubricate (i.e. control bar, discharge
X
fl ipper, folding tray, winch rollers, etc.)
Dry lube (swivel discharge, chain
X
driven feedwheels, etc.)
X Grease to reduce wear
X Lubricate inner cable & ends SAE 10W/30
3 Months Grease as needed
Grease per MFG's instructions
Grease or oil per MFG's instructions
Grease per MFG's instructions
54
MAINTENANCE
5
5
Bandit