Bandit INTIMIDATOR 15XP/1390 Operating & Parts Manual page 63

MODEL 15XP/1390
1. Check towing hitch:
Check for excessive damage or wear. Replace if
needed. Keep pintle ring greased to reduce wear.
2. Check discharge and infeed hopper wear:
Check for wear on discharge, infeed hopper, and
discharge direction adjustor; build up, repair or
replace as needed.
3. Inspect feedwheel motor connections:
Check and maintain correct torque, on feedwheel
motor connections. See page 66.
4. Check feedwheel teeth for sharpness:
Replace if needed.
5. Check chipper bearings and chipper sheave:
Check, retighten all bearing bolts, bearing lock
collars, and also belt sheave bushings to correct
torques.
6. Check hydraulic function pressures:
Check, reset and maintain all hydraulic function
pressure settings to a maximum of the specified
PSI (bar). This will give you the best performance
from the hydraulic system.
1. Hydraulic oil filter(s):
Must be replaced after FIRST 10 HOURS OF
OPERATION, USE A 10 MICRON FILTER. After first
change replace oil filter every 3 months or 400 hours.
2. Grease discharge swivel plates:
Grease swivel plates for discharge as needed.
1. Hydraulic oil:
Change hydraulic oil and flush the hydraulic reservoir
tank.
2. Hydraulic suction screen(s):
Change hydraulic suction screen(s) yearly or every
2000 hours.
Copyright 9/18
MONTHLY MAINTENANCE
3 MONTH MAINTENANCE
YEARLY MAINTENANCE
7. Check wheel bearings:
Check and grease or oil wheel bearings per axle
manufacturer's instructions.
8. Check and adjust brakes:
Check and adjust brakes as needed per axle MFG.
manual.
9. Check discharge chain tension (if equipped):
Check tension on hydraulic or hand crank swivel
discharge chain drive and tighten as necessary.
Chain tension is 1/4" (6 mm) per foot (0.3 m) of center
distance between sprockets, NOT to exceed a 1/2"
(13 mm) of deflection. Do not overtighten, which may
result in hydraulic motor failure.
10. Lubricate "Bandit" lever throttle cable:
If the machine is equipped with a "Bandit" lever
throttle system, lubricate inner throttle cable and
cable ends with a cable lube or SAE 10W/30 oil.
Replace throttle cable if it doesn't operate smoothly.
3. High pressure oil filter(s) (if equipped):
Must be replaced after FIRST 10 HOURS OF
OPERATION. After first change replace oil filter every
3 months or 400 hours.
3. Fuel tank:
Drain and clean the fuel tank yearly.
47
MAINTENANCE
Bandit