Bandit INTIMIDATOR 15XP/1390 Operating & Parts Manual page 36

MODEL 15XP/1390
Decals located on your Bandit equipment contain useful information to assist you in operating your equipment
safely. Some of the decals on your machine and their location are shown in this section.
It is very important that all decals remain in place and in good condition on your machine. Please follow
the care and instructions given below.
1. You should use soap and water to keep your decals clean. Never use mineral spirits or any other
abrasive cleaners.
2.
Immediately replace any missing or damaged decals. The location the decal is going to be applied
to must be clean and dry, and at least 40°F (5°C) before applying decal.
3. When the need arises to replace a machine component with a decal attached, be sure and replace
the decal.
4. Replacement decals are available, and can be purchased from the manufacturer or your Bandit Dealer.
5. Peel back about half of the backer paper on the decal. Position it on the fl at, dry, clean surface so it
is smooth and secure. Peel off the remainder of the backer paper as you continue to stick the decal
on the surface.
6. Rub decal from the center outward to remove air bubbles and to secure contact.
7. Combination English / Spanish decals are typically standard. Other foreign language decals are
available and may be purchased. Mail translated decals required to Bandit Industries, Inc.
EXAMPLES:
NOTICE
THE CLUTCH SHOULD NOT BE ENGAGED
OR DISENGAGED AT ENGINE SPEEDS ABOVE
LOW IDLE.
DO NOT operate this Clutch/PTO unless proper adjustments and
lubrication are maintained per the Clutch/PTO Manufacturer's Manual.
Different brands and models require different service and operation
procedures. New Clutch/PTO's require more frequent adjustment.
GOOD OPERATORS
DON'T WASTE MONEY!
Clutches will fail, glaze over, and burn up from improper
adjustment. This will cost the owner of this machine
thousands of dollars to repair. A well maintained, correctly
adjusted clutch should function properly for years.
LEAVING THE CLUTCH DISENGAGED EVEN
FOR SHORT PERIODS OF TIME WILL
REDUCE PILOT BEARING AND CLUTCH
PLATE LIFE! REFER TO CLUTCH MANUAL FOR
OPERATING AND MAINTENANCE PROCEDURES.
Copyright 9/18
DECALS
N-07 1/18
22
DECALS
Bandit