Table of Contents
Advertisement
SKID STEER MOUNTING
READ THE 'OPERATION' SECTION OF YOUR SKID STEER OPERATOR'S MANUAL
BEFORE ATTEMPTING TO OPERATE THE SKID STEER AND SMR-800.
1. Check with your local Schulte dealer or the factory to ensure that you have the correct size hydraulic motor
for your make and model of skid steer.
2. Follow the instructions with your skid steer loader to quick attach the SMR-800 to the skid steer loader.
Before operating the multi-rake, carefully read the Safety and Operation Sections of this
Operator's Manual.
HYDRAULIC BLOCK
Refer to the Mount Section of the Parts Manual
1. Insert two #12 M-ORB to #10 M-JIC fittings into
the ports on the Hydraulic Block.
2. Insert two #12 M-ORB to #10 M-JIC 90° elbow
fittings into the ports on the Hydraulic Block.
3. Insert two #6 M-ORB Plugs into the top two #6
ports.
4. Insert two #6M-ORB to #6 M-JIC fittings into
the remaining two ports.
5. Secure the Hydraulic Block to the Mount using
three 3/8"x3/4" bolts.
6. Mount this assembly onto the frame using the
two U-bolts supplied and four 5/8" Locking
Flange Nuts.
7. Connect hoses and route as shown in your
Parts Manual.
8. Attach the Solenoid Plugs from the electrical
harness to the solenoids.
SMR-600 04/21
© 2019 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-4
Advertisement
Table of Contents
