Skid Steer Pre-Operation Inspection/Service; Windrower Pre-Operation Inspection/Service - Schulte SMR-600 Operator's Manual

Multi-rake
Table of Contents

Advertisement

Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.

6.1 Skid Steer Pre-Operation Inspection/Service

Refer to the power unit operator's manual to ensure
a complete pre-operation inspection and scheduled
service is performed according to manufacturer
recommendations. The following is a partial list of
items requiring inspection:
Tire condition/air pressure
Wheel lug bolts
Steering linkage
SMV sign is clean and visible
Power Unit lights are clean and functional
Power Unit Seat belt is in good condition
Power Unit cab or ROPS is in good condition
ROPS is in the raised position
No power unit oil leaks
Radiator free of debris
Engine oil level and condition
Engine coolant level and condition
Power brake fluid level
Power steering fluid level
Fuel condition and level
Sufficient lubrication at all lube points
Air filter condition pins
Lift arms and mount are in good condition
Operator protective door condition and free of damage
Mounting interface is in good condition and free of damage

6.2 Windrower Pre-Operation Inspection/Service

Before each implement use, a complete inspection and service is required to ensure the implement is in a
good and safe working condition. Damaged and/or broken parts should be repaired and/or replaced
immediately. To ensure the implement is ready for operation, conduct the following.
Inspect windrower teeth for excessive wear and damage. The teeth should not be bent or crooked and all
welds and fasteners should be intact and secure.
The teeth are made from high strength abrasion resistant 450BHN steel which provides superior wear
resistance. However, under certain operating conditions, some wear is to be expected.
Hydraulic motor is in good condition and free of damage.
SMR-600 04/21
© 2019 Alamo Group Inc.
OPERATION
(SG-21)
Operation Section 4-10

Advertisement

Table of Contents
loading

Table of Contents