Table of Contents
Advertisement
Use hand rails and steps when exiting the skid steer. Be careful of your step and use extra caution when mud,
ice, snow or other matter has accumulated on the steps or hand rails. Use all handrails and steps for support
and never rush or jump off the skid steer.
4. STARTING THE SKID STEER
The operator must have a complete understanding of the placement, function, and operational use of all skid
steer controls before starting the skid steer. Review the skid steer operator's manual and consult an authorized
dealer for operating instructions if needed.
Essential Skid Steer Controls:
•
Locate the light control lever.
•
Locate the engine shut off control.
•
Locate the brake pedals and the clutch.
•
Identify Skid Steer Joystick movement layout.
•
Identify Boom Lift and Tilt Control layout.
•
Locate the auxiliary hydraulic control lever.
•
Locate the boom height foot controls (if equipped).
•
Locate the hitch tilt foot controls (if equipped).
Before starting the skid steer ensure the following:
•
Conduct all pre-start operation inspection and service according to the skid steer operator's manual.
•
Make sure all guards, shields, and other safety devices are securely in place.
•
The parking brake is on.
•
The skid steer transmission is in neutral.
•
The auxiliary hydraulics are disengaged.
•
The boom height/tilt controls are in the neutral position.
Refer to the skid steer owner's manual for procedures to start the skid steer. Only start the skid steer while
seated and belted in the operator's seat. Never bypass the ignition switch by short circuiting the starter
solenoid.
After the engine is running, avoid accidental contact with the skid steer transmission to prevent sudden and
unexpected skid steer movement.
Never run the Power Unit engine in a closed building or without adequate ventilation. The
exhaust fumes can be hazardous to your health.
Start the Power Unit only when properly seated in the Power Unit seat. Starting
a Power Unit in gear can result in injury or death. Read the Power Unit
Operator's Manual for proper starting instructions.
SMR-600 04/21
© 2019 Alamo Group Inc.
OPERATION
Operation Section 4-7
(SPU-23)
(SPU-19)
Advertisement
Table of Contents
