Equipment Operation Safety Instructions And Practices - Schulte SMR-600 Operator's Manual

EQUIPMENT OPERATION SAFETY INSTRUCTIONS AND PRACTICES

Never leave the Power Unit and Implement unattended while the Implement is in the lifted
position. Accidental operation of lifting lever or a hydraulic failure may cause sudden drop of
unit with injury or death by crushing. To properly park the implement when disconnecting it
from the Power Unit, lower the stand and put the retaining pin securely in place, or put a
secure support under the A-Frame. Lower the implement carefully to the ground. Do not put
hands or feet under lifted components.
There are obvious and hidden potential hazards in the operation of this implement as in all
power-driven or pulled equipment. REMEMBER! This machine is often operated in rough
terrain conditions that include tall grass, weeds, gullies, holes, slopes, hidden obstructions
and the like. Serious injury or even death may occur unless care is taken to assure the
safety of the operator and bystanders in the area. Do not operate this machine with anyone
in the immediate area
Make sure the PTO shield, integral driveline shields, and input shields
are installed when using PTO-driven equipment.
shield if it is damaged or missing.
Operate this Implement only in conditions where you have clear visibility in daylight or with
adequate artificial lighting. Never operate in darkness or foggy conditions where you cannot
clearly see at least 100 yards in front and to the sides of the tractor and implement. Make
sure that you can clearly see and identify passersby, steep slopes, ditches, drop-offs,
overhead obstructions, power lines, debris and foreign objects. If you are unable to clearly
see these types of items discontinue operating this equipment.
Operate this Equipment only with a Power Unit equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or even
death could result from falling off the Power Unit--particularly during a turnover
when the operator could be pinned under the ROPS.
BEFORE leaving the Power Unit seat lower the implement, set the
parking brake and/or set the Power Unit transmission in parking gear,
stop the engine, remove the key, and wait for all moving parts to stop.
Place the power unit shift lever into a low range or parking gear to
prevent the power unit from rolling. Never dismount a Power Unit that is
moving or while the engine is running. Operate the power unit controls
from the power unit seat only.
SMR-600 04/21 SMR-600 04/21
© 2019 Alamo Group Inc.
SAFETY
(S3PT-07)
(S3PT-8)
Safety Section 1-6 Safety Section 1-6
Always replace any
(S3PT-21)