Getting On And Off The Skid Steer; Boarding The Skid Steer; Dismounting The Skid Steer - Schulte SMR-600 Operator's Manual

Multi-rake

Table of Contents

3. GETTING ON AND OFF THE SKID STEER

Before getting onto the skid steer, the operator must read and completely understand the implement and skid

steer operator manuals. If any part of manual is not completely understood, consult an authorized dealer.

Do not mount the Power Unit while the Power Unit is moving. Mount the

Power Unit only when the Power Unit and all moving parts are

completely stopped.

Use both hands and equipped handrails and steps for support when getting on the skid steer. Never use

control levers for support when mounting. Always seat yourself in the operator's seat and fasten the seat belt.

Never allow passengers to ride on the skid steer or implement. Riders can easily fall off and be seriously

injured or killed from being ran over. It is the operator's responsibility to forbid additional riders.

Never allow children or other persons to ride on the Power Unit or

Implement. Falling off can result in serious injury or death.

Do not mount the Power Unit while the Power Unit is moving. Mount the

Power Unit only when the Power Unit and all moving parts are

completely stopped.

Before dismounting, park the skid steer and implement on a reasonably level surface, apply the parking brake,

idle the engine down, disengage the auxiliary hydraulics, and lower the implement to the ground. Shut down

the skid steer engine according to the operator's manual, remove the key, and wait for all motion to completely

stop. Never leave the seat until the skid steer, its engine and all moving implement parts are completely

stopped.

BEFORE leaving the Power Unit seat, always engage the brake and set the Power Unit

transmission in parking gear, disengage the auxiliary hydraulics, stop the engine, remove

the key, and wait for all moving parts to stop. Place the Power Unit shift lever into a low

range or parking gear to prevent the tractor from rolling. Never dismount a Power Unit that

is moving or while the engine is running. Operate the Power Unit controls from the

operator seat only.

SMR-600 04/21

OPERATION

(SPU-18)

(SPU-15)

Operation Section 4-6

(SPU-16)

Table of Contents