Replacing The Auxiliary Control Unit-Part Number Cts-Light-Ctrl - Cisco 3000 Use & Care Manual

Chapter 11 Field-Replaceable Unit Guide
Replacing the Auxiliary Control Unit—Part Number
CTS-LIGHT-CTRL=
The auxiliary control unit is located in the center of the display assembly. For more information about
the auxiliary control unit, refer to the
Cisco TelePresence Hardware Options and Upgrade
Turn the power switch on the auxiliary control unit to Off and remove the plug from the wall receptacle.
Step 1
See
Mark each power, and (if present) video cable with its location on the auxiliary control unit.
Step 2
Remove the auxiliary control unit from the rear of the display assembly.
Step 3
Attach the replacement auxiliary control unit.
Step 4
Step 5 Plug in the cords and (if present) video cables that were removed and turn the power switch to the On
position.
Note Connect port 1 of the "Video in" connection from the codec, and port 4 of the "Video out" connection
to the projector.
Plug the power cord into the wall receptacle.
Step 6
Open a browser on a computer connected to the network.
Step 7
Type in the IP address of the center, primary codec unit. Enter the required information at the login
Step 8
screen. The Cisco TelePresence Administrator window appears.
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
Step 9
window) is Enabled/Up.
Choose System Restart to perform a software reset.
Step 10
Refer to the
information.
OL-14521-01
Figure 7-20 for the location of the auxiliary control unit.
Cisco TelePresence System Administrator's Guide
Replacing the Auxiliary Control Unit—Part Number CTS-LIGHT-CTRL=
"Options for the Cisco TelePresence System 3000"
Guide.
for your software release for more
chapter of the
Cisco TelePresence System 3000
11-27