Cisco 3000 Use & Care Manual page 171

Chapter 9 First-Time Setup
d.
e.
f.
Figure 9-6 Correct Camera Target Alignment—Right Display
g.
h.
OL-14521-01
Place the small target on the table in front of the large target, and adjust the focus by completing the
steps in the "Focusing the Camera" section on page
Remove the large target from the center part of the table, and attach it to the left part of the table,
placing the underside of the clamps into the recessed holes.
Make manual adjustments to the camera focused on the target and the zoom ring on the camera to
make the following adjustments to the camera:
Align the red plus sign to the plus sign in the middle of the target.
•
Align the red hash marks on the display so that they fit between the table edges.
•
• Zoom and align the camera so that the curved line on the right side of the display touches the
red adjustment line at the right edge of the display as shown in
To adjust the camera left and right or up and down, or to make vertical adjustments, use the
adjusting screws as shown in
If one of the left/right screws is covered by the camera cable, use the other screw to make
Note
all left/right adjustments.
Place the small target on the table, in front of the large target, and adjust the focus by completing
the steps in the "Focusing the Camera" section on page
Remove the large target from the center part of the table, and attach it to the right part of the table,
placing the underside of the clamps into the recessed holes.
9-13.
Figure 9-4.
9-13.
Setting Up CTS Components
Figure 9-6.
Red
Vertical line
Red plus
sign within
black cross
Red lines
Table
edge
Cisco TelePresence System 3000
9-11