Cisco 3000 Use & Care Manual page 163

Chapter 9 First-Time Setup
Figure 9-2
Note If the IP address that displays is 192.168.100.2, the CTS-3000 could not contact the DHCP server or your
system does not use DHCP. If your network does not use DHCP, navigate to Configuration > IP
Settings, change the DHCP Enabled setting to No, and specify a static IP address, subnet mask, gateway
and DNS server. You must reboot your codec after you configure a static IP address.
After successful bootup, the CTS Administration Software loads. When CTS Administration Software
completes loading, the Cisco IP telephone displays a welcome message that displays the system IP
address. The welcome screen only appears the first time the system is booted up after initial installation
or after a factory reset.
Note The telephone displays a directory number of 7000, but the telephone is not yet registered and does not
function.
If you have not already done so, configure the Cisco Unified Communications Manager GUI. For
Step 3
detailed instructions to configure Cisco Unified Communications Manager for use with your CTS 3000,
refer to the
System
OL-14521-01
System IP Address
Cisco Unified Communications Manager Installation Guide for the Cisco TelePresence
for your software release.
Loading CTS Administration Software
Cisco TelePresence System 3000
9-3