Cisco 3000 Use & Care Manual page 162

Loading CTS Administration Software
Make sure that you power on all codecs within 30 seconds to avoid power on detection failure.
Note
After you turn on the codecs, the displays associated with each codec becomes active. CTS displays
green check marks on all displays to show bootup progress. Bootup is complete when the system
displays six check marks as shown in
Figure 9-1
If the last check mark displayed is a red "X," there has been a compact flash error; if you receive this
Note
error, contact Cisco Technical Support.
Step 2 After bootup completes, make a note of the IP address that displays on the center of the screen as shown
in Figure
IP address displays until you log in to Cisco TelePresence System Administration or use Secure Shell
(SSH) to log in to the CTS 3000.
Cisco TelePresence System 3000
9-2
Bootup Completed
9-2. You use that information to log in to the Cisco TelePresence System Administration. This
Figure 9-1.
Chapter 9 First-Time Setup
OL-14521-01