Assembly Screen Supports; And M8 X 30 Mm Screws; Determining The Display Shelf Type - Cisco 3000 Use & Care Manual

Chapter 5 Building the Display Shelf Assembly
3

Assembly Screen Supports

4 and M8 x 30 mm screws
12
The shelf segments are unstable during assembly. Use caution, and support all structures as required.
Caution
Caution Some system components have metal and plastic edges with hard angles. These edges are exposed until
you complete system assembly. Use caution when you move around the system during assembly to avoid
contact with any exposed system edges.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
In order to prevent scratching the Display shelves, you should avoid putting any tools on the shelf
Caution
surfaces.
The directions left and right refer to the assembly as you face the Plasma displays.
Note
Note

Determining the Display Shelf Type

The CTS 3000 ships with two different types of shelves. Determine the type of shelf that you have by
one of the following methods:
•
•
OL-14521-01
This illustration describes the hardware used to attach the three Display shelves and the
hardware used to attach additional assemblies in
Cisco TelePresence Elements."
Display structures, as illustrated in
Check the cartons that shipped with your product.
Display shelves with a product ID of CTS3K-FUR-MAPLE come in a single wooden box and
–
are packed with the other table sections. Complete the steps in the
Assembly, Product ID CTS3K-FUR-MAPLE" section on page
Display shelves with a product ID of CTS3K-M-TABLE-G2 are packaged in separate cardboard
–
boxes and one wooden box. The part number is 69-1640-xx. Complete the steps in the
the Display Shelf Assembly, Product ID CTS3K-M-TABLE-G2" section on page
Check the attachment hardware for the shelves.
Display shelves with a product ID of CTS3K-FUR-MAPLE use cam locks, cam lock rods, and
–
plates to attach the sections.
No part number 2
69-1706-xx 14
Chapter 7, "Assembling the Remaining
The Display shelves should be attached individually to the
Figure 5-3, Figure
Determining the Display Shelf Type
1 These brackets might also be
located inside of the assembly
cabinet.
1
5-4, and Figure 5-5.
"Building the Display Shelf
5-5.
Cisco TelePresence System 3000
"Building
5-10.
5-3