Cisco 3000 Use & Care Manual page 198

Replacing a Plasma Display—Part Number CTS-DISP-65-GEN4=
Figure 11-2
Turn the power switch on the Plasma display to the On position.
Step 10
The rear of the replacement display will have either two HDMI connectors (see
Step 11
connectors (see
If the replacement display has two HDMI connectors, connect your existing signal cable to the codec
and to the left-most HDMI connector on the rear of the display (as viewed from the rear of the display),
as shown in
If the replacement display has two DVI connectors, connect the signal cable supplied with the
replacement display to the codec and to the left-most connector on the rear of the display (as viewed
from the rear of the display), as shown in
Cisco TelePresence System 3000
11-10
Attaching the Display Mounting Bracket
Figure 11-4).
Figure 11-3.
Chapter 11
Figure 11-4.
Field-Replaceable Unit Guide
Figure 11-3) or two DVI
OL-14521-01