Determining The Table Section Type - Cisco 3000 Use & Care Manual

Determining the Table Section Type

Table elements are heavy, and metal edges can be very sharp. Protect your hands and eyes from injury
Caution
by wearing safety gloves and glasses.
In order to prevent scratching the table tops, you should avoid putting any tools on the table surfaces.
Caution
The directions left and right refer to the assembly as you face it from the front.
Note
Table legs are unstable until they are fully attached to the tabletop. Do not use unattached table legs
Warning
as tabletop supports while you attach tabletop segments. They can fall and cause injury or damage.
Cisco suggests you use the accessory cabinets to support and stabilize the table segments as you
install them.
Determining the Table Section Type
The CTS 3000 ships with two different types of table sections. Determine the type of section that you
have by one of the following methods:
•
•
Cisco TelePresence System 3000
6-4
Check the cartons that shipped with your product.
– Table sections with a product ID of CTS3K-FUR-MAPLE come in a single wooden box and are
packed with the other table sections. Complete the steps in the
Product ID CTS3K-FUR-MAPLE" section on page
Table sections with a product ID of CTS3K-M-TABLE-G2 are packaged in separate cardboard
–
boxes and one wooden box. The part numbers are 69-1638-xx and 69-1639-xx. Complete the
steps in the "Building the Table Assembly, Product ID CTS3K-M-TABLE-G2" section on
page 6-18.
Check the attachment hardware for the table sections.
Table sections with a product ID of CTS3K-FUR-MAPLE use cam locks, cam lock rods, and
–
plates to attach the sections.
Table sections with a product ID of CTS3K-M-TABLE-G2 use draw bolts to attach the sections.
–
Chapter 6 Building the Table Assembly
"Building the Table Assembly,
6-5.
OL-14521-01