Cisco 3000 Use & Care Manual page 152

Power Requirements for the Cisco TelePresence 3000
Step 13 Attach the ferrite cores to the ends of all six camera cables (both the video and Ethernet cables, 12 ferrite
cores total).
Wrap the cables around the ferrite as shown in
approximately 1 1/2 inches (4 cm) from the connectors.
Figure 8-13
Step 14 Connect the cables between the primary and secondary codecs.
Note If you ordered a Presentation Codec or Auxiliary Control Unit with your TelePresence system, see
Figure 8-16
Cisco TelePresence System 3000
8-16
Connecting the Ferrite Cores
14
for additional cabling information.
Chapter 8
Figure 8-13. Attach the ferrite cores so that they are
14
Routing Power and Signal Cables
OL-14521-01