Back Feed Restriction Setting (Backfeed Limit) - Toshiba B-FP2D Series Key Operation Specification

7.3.8

Back Feed Restriction Setting (Backfeed Limit)

・
OFF Back feed not restricted (Performs a back feed.)
・
ON Back feed restricted (Performs no back feed.)
Default value: ON (Back feed restricted)
<Commentary>
 During label issue with sensor type specified (transmissive/reflective sensor) under the following conditions, this
setting determines whether or not to perform a back feed.
However, when linerless setting is enabled, the following conditions are ignored and whether or not to perform a
back feed is determined according to this setting.

The label pitch is 20.0 mm or more and less than 24.0 mm and the effective print length is less than 15.0
mm.

The label pitch is less than 20.0 mm.
 During label issue without sensor type specified, whether or not to perform a back feed is determined according
this setting.
 When a feed is performed by using the [FEED] key or the Feed command, no back feed is performed.
However, when the label pitch is less than a distance between the head and the sensor (14.0 mm), a back feed
is performed regardless of this setting.
<Notes>
- If the setting is OFF, it stops at cut position in case 7.3.7
is HEAD.
*Support mode (o：valid、x：invalid）
TPCL, TPCL1,
LABEL
o
C Mode ESC/POS
RECEIPT,RECEIP
T1
o o
Post-print Stop Position Setting (Stop Position)
Z Mode
o
-61-
S Mode
o