Table of Contents
Advertisement
<Supplementary Explanations>
(1) To program the threshold, 1.5 labels or more should be fed. (If the label is not fed by the above amount,
the threshold may not be properly programmed. In this case, reprogramming is required.)
(2) While the printer is feeding a label to program the threshold, an error detection including the paper end
or cutter error is not performed.
(3) When the proper print position is not obtained after threshold programming, the sensor may be
improperly adjusted. In this case, readjust the sensor in system mode, and program the threshold.
When the backing paper of the label is too thick, the transmissive sensor should be readjusted. In
addition, make sure that "3: Transmissive sensor (when using a manual threshold value)" or "4:
Reflective sensor (when using a manual threshold value)" is selected for sensor type of the Feed
Command and the Issue Command.
-16-
Advertisement
Table of Contents
