Table of Contents
Advertisement
5.2 KEY FUNCTIONS
[POWER] key
(1) Turns the printer power on from a power off state and initializes the printer.
(2) Performs various parameter settings.
[FEED] key:
(1) Feeds or ejects 1 label. This key is also used to adjust a label to a proper position.
(2) Prints data in the image buffer on one label (depending on TPCL1 mode, LABEL mode).
(3) Performs a forced strip issue in strip wait state.
(4) Programs a threshold value.
[PAUSE] key:
(1) Stops printing temporarily and resumes printing.
(2) Resumes printing after clearing an error.
Key operations while the printer is in online state
In pause state
Press [PAUSE]:
Hold down [PAUSE]: Moves to the reset menu.
Press [FEED]:
Hold down [FEED]:
In error state
Press [PAUSE]:
Hold down [PAUSE]: Moves to the reset menu.
Press [FEED]:
When the label is not properly positioned, feed 1 or 2 blank labels using this key before
printing so that the printer can start printing at the proper position.
NOTE:
During printing initiated by the [FEED] key, a Clear command or a drawing
command should not be sent from the host device, otherwise the resulting
printout will not be satisfactory showing an incorrect layout. The same may
happen if the [FEED] key is pressed to start printing while data is being drawn in
the image buffer.
Exits from a pause state.
Feeds a paper.
Moves to the threshold setting menu.
Recovers from an error.
No operation
-4-
Advertisement
Table of Contents
