7.6.1
This menu enables setting print conditions for test print.
Contents of TEST PRINT menu
MENU ITEM
6.Test Print
Print Condition
Issue Count
Sensor
Print Type
Label Length
Paper Feed
<Supplemental Explanations>
・ Default value at power on is:
Issue count
Sensor
Label Length
Paper Feed
・ Each fine adjustment parameter is effective for test print. However, the X-coordinate fine adjustment is
excluded.
・ When an error occurs during a test print, the error message is displayed and printing is stopped. The
STATUS LED blinks and the CHARGE LED turns off.
・ The error is cleared by a depression of the [PAUSE] key, and the display returns to the test print menu. The
STATUS LED turns on and the CHARGE LED turns off. Printing is not automatically resumed after the
error is cleared.
・ When the transmissive sensor is selected, the gap between labels shall be 3 mm.
Print Condition
1
NONE
63mm
NO FEED
-87-