Operation During Battery Charge By Ac/Usb Power Supply; In Printer Power Off State - Toshiba B-FP2D Series Key Operation Specification

10

Operation during battery charge by AC/USB power supply

This chapter describes the printer operations when the battery is charged through the AC adapter or USB cable.

10.1 In Printer Power Off State

(1) When the AC adapter or USB cable is being connected with the battery installed:
LCD
No display (Same as power off)
LED
[STATUS] LED (blue)
[CHARGE] LED (Orange)

If a USB cable is connected to the printer and the printer power is turned on under the above condition, the USB
interface may not work.
(This symptom occurs only when the USB cable is connected to the printer anytime between a connection of
the AC adapter in the printer power off state and a power on under the above condition.) This problem can
be solved by turning off the printer after disconnection of the AC adapter or removing and inserting the battery
again.
(2) When the USB cable is connected without the battery installed:
LCD
No display (Same as power off)
LED
[STATUS] LED (Red)
[CHARGE] LED

If the printer power is turned on under the above condition, a charge error will result.
(For details about the charge error, refer to "5.11 Charge Error Number List" of this specification and
Chapter 8. Error Processing of the External Equipment Interface Specification.)
(3) When the AC adapter is connected without the battery installed:
LCD
No display (Same as power off)
LED
[STATUS] LED
[CHARGE] LED

In the above case, the printer cannot be turned on.
................................... OFF
Charging ..................... ON
Full charge ................. OFF
......... ON (Blink)
......... OFF
......... OFF
......... OFF
-118-