Table of Contents
Advertisement
1 • Introduction
The Control Panel
The control panel can be positioned on either side of the stacker,
depending on system configuration.
To change the position of the control panel, pull the panel firmly towards
you to remove it. Refit the control panel to the opening on the opposite
side of the belt stacker.
Power switch
For switching main
power on/off.
Principle of Operation
The belt will start as soon as the start sensor is covered. When the
material has moved out of the sensor area, the belt will stop again. The
Start sensor position is adjustable, which allows the material overlap to be
adjusted.
The speed of the belt can be adjusted in order to optimize the stacking
function for various materials.
The Run-out button is used to gather the material after a job is finished.
The belt moves at the highest speed, independent of the Speed Selector
setting.
1-4
6
4
2
0
10
Speed Selector
For setting belt speed.
8
Run-out button
Runs the belt at
full speed - when
you want to gather
the material on the
stacking tray.
SV40231 Rev. B
Advertisement
Table of Contents
